Mountain and coastal FPV flying with the AKK TX5000AC: a lightweight analog video setup from the customer’s long-range case.
Application imagery is illustrative.
A team flying across mountains and islands wanted a lighter video system and more usable feedback as the signal weakened.
The customer describes abrupt picture loss with its previous digital setup at the edge of reception. Mountain and sea-surface reflections, aircraft weight and time to make a return decision were the main concerns.
The case pairs a 7-inch or 10-inch long-range aircraft with the AKK TX5000AC: up to 5 W output, 96 channels and a transmitter weight of 25 g excluding the antenna. The ground setup uses a high-gain directional antenna and low-loss feeder cable.
The customer reports a 30 km line-of-sight video link over mountain or coastal terrain, with increasing picture noise as the signal weakened. The draft also reports 120 g less total aircraft weight and 10 minutes more endurance than its previous setup. These are customer-reported comparisons, not independently verified results or guaranteed performance.
Onboard camera → AKK TX5000AC → ground receiver with directional antenna → pilot display.
Explore the transmitter featured in this application and its specifications.
The AKK TX5000AC is the transmitter featured in the long-range FPV application, with SmartAudio control and built-in fan cooling.
Allow for antenna and cable weight separately. Confirm the supplied version and receiving setup before selecting the model.
View product detailsEquipment described in the customer’s long-range application.
| Component | Case configuration |
|---|---|
| Flight platform | 7-inch or 10-inch long-range FPV aircraft, as described in the customer case. |
| Video transmitter | AKK TX5000AC, up to 5 W, 96 channels, 25 g excluding antenna. |
| Ground receiving setup | High-gain directional antenna and low-loss feeder cable connected to compatible receiving equipment. |
Key details about the video link.
The AKK TX5000AC analog video transmitter. See its product page for dimensions, output settings and installation information.
The camera, receiver, antennas and display are separate parts of the video system. Matching their interfaces and frequencies is part of the equipment review.
Share your current equipment and the requirements you want to evaluate.